How To Use The HeartCheck™ ECG Monitor Device

Device Overview



  1. POWER button: Power the Unit on or off.
  2. Metal Electrode 1, 2: Hold these two with right index finger when taking a measurement.
  3. START button: The shortcut key for ECG measurement.
  4. OK button: Press this button to confirm the selection or select date item when in the date and time setting.
  5. Down Arrow/Right Arrow button: Press this button to move the cursor to your desired menu or change the number, or move the waveform to the left.
  6. Up Arrow/Left button: Press this button to move the cursor to your desired menu or change the number, or move the wavefirn to the right.
  7. MENU button: You can returnt to the previous menu by pressing this button.
  8. ECG Cable Socket: When taking a measurement with the ECG cable, connect the ECG cable to this port.
  9. Left thumb Electrode.
  10. Metal Electrode 3, 4: Place this agains't the center of left palm, chest, or left hip, when taking a measurement.
  11. USB Interface: Transmits data to the PC through this interface.



  • Do not expose the unit to static electricity. Always disperse any static electricity from your body before handling the device.
  • Do not take measurements in a moving vehicle.
  • Do not use a cellular phone near the unit.
  • The chest electrode will be impeded by excessive body hair. Regularly remove hair at the electrode contact area.

Taking Heart Readings




Palm Measurements
The quickest and easiest ECG Measurement

STEP 1: Press the 'POWER' button to power on the unit.



STEP 2: Press the 'START' button to enter preparing stage.



STEP 3: During the preparation stage, hold the electrode with your hands as shown. Please ensure your hands make full contact with the electrodes for a high quality ECG result.




STEP 4: After finishing preparing stage, the ECG measurement will take 30 seconds for a measurement (under Easy mode). after taking the measurement the monitor will analyse the results. Press 'SAVE' to save the results.

Chest Measurements
For a higher quality ECG Measurement

STEP 1: Press the 'POWER' button to power on the unit.



STEP 2: Press the 'START' button to enter preparing stage.




STEP 3: Holding the unit with your right hand, place the electrode againts the left side of your chest (on bare skin) about 5cm below left nipple.





STEP 4: After finishing preparing stage, the ECG measurement will take 30 seconds for a measurement (under Easy mode). after taking the measurement the monitor will analyse the results. Press 'SAVE' to save the results.

Stomach Measurements
For a higher quality ECG Measurement

STEP 1: Press the 'POWER' button to power on the unit.



STEP 2: Press the 'START' button to enter preparing stage.




STEP 3: Holding the unit with your right hand, place the electrode againts the left side of your stomach (on bare skin) as shown.




STEP 4: After finishing preparing stage, the ECG measurement will take 30 seconds for a measurement (under Easy mode). after taking the measurement the monitor will analyse the results. Press 'SAVE' to save the results.

Cable Measurements
For the highest quality ECG Measurement

STEP 1: Press the 'POWER' button to power on the unit.



STEP 2: Plug the electrode cable into the ECG port.




STEP 3: Place the white electrode under your right collar bone. Place the red electrode under your left collar bone. The black electrode is to be placed under the left breast.




STEP 4: Press the 'START' button to enter preparing stage.




STEP 5: After finishing preparing stage, the ECG measurement will take 30 seconds for a measurement (under Easy mode). after taking the measurement the monitor will analyse the results. Press 'SAVE' to save the results.

IMPORTANT MESSAGE:
Self Measurment is not the same as medical diagnosis. Please consult your doctor.